Supporting Industry Standard Server Solutions

Question 1

In which direction does the air flow through a c7000 enclosure?

A. bottom to top

B. back to front

C. top to bottom

D. front to back

Correct Answer: D

Question 2

How do you boot into Intelligent Provisioning on a ProLiant Gen8 server?

A. by pressing the F9 button during POST

B. through the Array Configuration Utility (ACU) in offline mode

C. pressing the F10 button during POST

D. through a Scripting Toolkit server configuration script

Correct Answer: C

Explanation: Only visible for Actualtests4sure members. You can sign-up / login (it's free).

Question 3

An engineer repaired a memory problem in a ProLiant BL460c Gen8 server blade running Windows 2008 R2. What should the engineer do to verify the repair? (Select two.)

A. Reseat the memory and inform the customer when the job is done.

B. Reboot the BL460c Gen8 server and run the offline Insight Diagnostics.

C. Observe the server console for POST errors.

D. Check the Active Health System.

E. Observe the Insight Display at the front of the server after it boots.

Correct Answer: B,E

Question 4

How wide must the a data center door be to allow an HP MCS G2 rack to be brought into the data center?

A. 60 cm (2 feet)

B. 45 cm (1.5 feet)

C. 110 cm (3.6 feet)

D. 80 cm (2.5 feet)

Correct Answer: C

Question 5

A support engineer is troubleshooting a ProLiant DL360p Gen8 server.A hard disk m a four drive RAID 5 set has failed.The engineer notices that on three of the drives, the LEO labeled D on the exhibit is on.What does the condition indicate?

A. Hot swapping of the failed drive is not supported in this condition

B. The drives should not be removed when this LED is illuminated

C. The LED indicates failure and predictive failure alerts. Two additional drives in the RAID set are at risk of failing and need to be replaced

D. The drive failure has corrupted three drives in the RAID set. The array must be rebuilt and data restored from backup

Correct Answer: B

Question 6

To boot a USB firmware memory key built by the HP USB key utility, where should an engineer insert the key to upgrade the firmware on the server blade?

A. USB key on the server blade

B. Redundant Onboard Administrator USB connector

C. SUV cable USB connector

D. Onboard Administrator USB port

Correct Answer: D

Question 7

Which software tool should you use to deploy an operating system to a ProLiant BL460c Gen8 server blade?

A. Intelligent Provisioning

B. Array Configuration Utility

C. System Management Homepage

D. SmartStart

Correct Answer: A

Question 8

Which type of memory is used on the HP Smart Array controller cache?

A. SRAM

B. RDRAM

C. DRAM

D. SDRAM

Correct Answer: C

Question 9

You are viewing the current driver and firmware status in the Version Control Agent (VCA) and notice that only one column of information is presented.
What must you do to see the current status and the latest revision available?

A. Configure the VCA to use the Version Control Repository Manager (VCRM).

B. Set up the central management server (CMS) to check for the latest Service Pack for ProLiant (SPP) and push it to the VCA.

C. Upgrade the System Management Homepage (SMH) VCA to the latest version to reflect the changes needed to access the new revisions.

D. Reboot the server to use the new VCA version, because the server has recently installed updates.

Correct Answer: C

HP Supporting Industry Standard Server Solutions - HP2-T23 Exam Practice Test

Latest Update

Useful Links

Contact Us