Cisco CCIE SP Written Exam, V3.0 Sample Questions:

1. router bgp 1 neighbor 1.1.1.1 remote-as 2 The above bgp configuration has what effect on the configured router?

A) Allows incoming TCP connections from 1.1.1.1 that are destined to port 179
B) Allows incoming TCP connections sourced from port 179
C) Allows incoming TCP connections from 1.1.1.1 that are sourced from port 179
D) Allows incoming TCP connections destined to port 179
E) Allows incoming TCP connections from 1.1.1.1 and destined to or sourced from port 179

2. Refer to the exhibit.

A company is deploying IPv6 using a dual-stack approach. OSPFv2 is used for IPv4 routing and is redistributed into the BGP IPv4 address family. The network engineer also needs to enable OSPFv3 for IPv6 routing using the same design that is used for OSPFv2. All prefixes in the OSPFv3 database must be redistributed into the BGP IPv6 address family at router R2, but R3 does not receive the loopback 0 IPv6 address of R2 via BGP. Which action will fix this problem?

A) redistribution of OSPFv3 routes into BGP with include-connected
B) redistribution of BGP routes into OSPFv3
C) mutual redistribution of OSPFv3 and BGP routes
D) redistribution of connected OSPFv3 routes

3. When the Cisco IOS OSPF command ip ospf dead-interval minimal hello-multiplier 5 is configured, which two statements are true? (Choose two.)

A) OSPF hello interval is 0.2 second
B) OSPF dead interval is 1 second
C) OSPF dead interval is 20 seconds
D) OSPF hello interval is 5 seconds
E) OSPF hello interval is 1 second
F) OSPF dead interval is 5 seconds

4. Which two statements about a backup tunnel to avoid the SRLGs of its protected interface are true? (Choose two.)

A) If it is not possible to avoid SRLG of the protected interface, backup tunnel will be created anyways.
B) If it is not possible to avoid SRLG of the protected interface, backup tunnel will not be created.
C) Manually created backup tunnel do automatically avoid SRLG of protected interfaces.
D) Backup tunnel can be created between IGP areas as long as SRLG is configured along the path.
E) Tunnel is not created unless it avoids SRLGs on the protected interface.

5. How would you characterize the source and type in a denial of service attack on a router?

A) By performing a show interface to see the transmitted load "txload" and receive load "rxload", if the interface utilization is not maxed out, there is no attack underway
B) By applying an access-list to all incoming and outgoing interfaces, turning off route-cache on all interfaces, then, when telnetting into the router perform a debug IP packet detail
C) By setting up an access-list to permit all ICMP, TCP, and UDP traffic with the log or log-input commands, then use the show access-list and show log commands to determine the type and source of attack
D) By perform a show ip interface to see the type and source of the attack based upon the access-list matches

Solutions: