Avaya Communication Server 1000 for Avaya Aura® Maintenance Sample Questions:

1. Click the Exhibit button.

A customer wants to allow a station user to save an incoming number (Off-Net, Local Number) to their Personal Directory and afterwards use it to place an outgoing call without having to perform an manual manipulation to the number.
Consider the customer dialing plan shown in the exhibit.
Communication Server 1000 is configured for DAPC = YES in the Route Data Block.
With reference to the DAPC Table options in the exhibit, which Dial Access Prefix on CLID (DAPC) table should be used?

A) Table 3
B) Table 4
C) Table 1
D) Table 2

2. Click the Exhibit button.

Consider a company's dialing plan shown in the exhibit and an example for its requirements:
A station user at the company, with Location Code 221, placed an ESN call, dialing 7-2212581. This would be an On-Net call and the NARS programming must remove the LOC code and dial the DN internally.
What programming would remove the location code for a call dialed within the originating Communication Server 1000 to a DN on that same Communication Server 1000?

A) The location codes for each site would be programmed under the LOC programming in Translation Table #2 at all locations.
B) Each site would have its own Location Code programmed as a Home Location Code (HLOC) under Translation Table #1 in their CS 1000.
C) Each site would have the Location Codes for all sites programmed as Home Location Codes (HLOC) in Translation Table #1 of their CS 1000.
D) Home NPA Codes (HNPA) for each site would be programmed under Translation Table #1 at each location in their CS 1000.

3. Click the Exhibit button.

Refer to the customer's dialing plan and programming show in the exhibits.
Assuming all required Route List Indexes have been programmed, why will the station user's dialed call of 8-1-717-398-8001 not complete?

A) 398-8001 would be denied under the SDRR programming
B) AC2 Access Code was not dialed
C) AC1 Access Code was not dialed
D) NPA 1717 is not provisioned in the customer's database

4. Click the Exhibit button.

A customer has a Communication Server 1000 RIs. 7 x system with System Manger / Unified Management (UCM) enabled. They have requested the addition of two new UCM Administrator User with the limited ability to provision telephones at each site. Refer to the exhibit for the roles current existing in the system.
Which action can the Network Administrator take to add these new accounts per the customer's requirements?

A) Change the built-in MemberRegister role to add the permissions required to allow telephone configuration.
B) Add a new TelephonyAdmin role with the specific permissions required to allow telephone configuration.
C) Change the built-in role Patcher role to remove all permissions except those that allow telephone configuration.
D) Assign the new users to the built-in NetworkAdministrator role because it has the permissions that allow telephone configuration.

5. A customer has a Communication Server 1000 RIs. 7 x system at their site. You have been asked to add the Call Pickup feature to the ten IP telephones in the sales department. The customer wants to be sure active calls are not lost when the change are made.
Which Phones Configuration feature can be enabled allowed you to ensure changes to the telephones are not transmitted to the call server until the telephone is not busy?

A) Courtesy change
B) Template change
C) Group change
D) Bulk change

Solutions: