Fortinet Certified Network Security Professional (FCNSP.v5) - FCNSP.v5 Exam Practice Test

Question 1
What advantages are there in using a hub-and-spoke IPSec VPN configuration instead of a fully-meshed set of IPSec tunnels? (Select all that apply.)

Correct Answer: A,D
Question 2
The diag sys session list command is executed in the CLI. The output of this command is shown in the exhibit.

Based on the output from this command, which of the following statements is correct?

Correct Answer: C
Question 3
Review the CLI configuration below for an IPS sensor and identify the correct statements regarding this configuration from the choices below. (Select all that apply.)
config ips sensor edit "LINUX_SERVER" set comment '' set replacemsg-group '' set log enable config entries edit 1 set action default set application all set location server set log enable set log-packet enable set os Linux set protocol all set quarantine none set severity all set status default next end next
end

Correct Answer: A,C
Question 4
In Transparent Mode, forward-domain is an attribute of ______________.

Correct Answer: B
Question 5
A network administrator connects his PC to the INTERNAL interface on a FortiGate unit. The administrator attempts to make an HTTPS connection to the FortiGate unit on the VLAN1 interface at the IP address of 10.0.1.1, but gets no connectivity.
The following troubleshooting commands are executed from the DOS prompt on the PC and from
the CLI.
C:\>ping 10.0.1.1
Pinging 10.0.1.1 with 32 bytes of data:
Reply from 10.0.1.1: bytes=32 time=1ms TTL=255
Reply from 10.0.1.1: bytes=32 time<1ms TTL=255
Reply from 10.0.1.1: bytes=32 time<1ms TTL=255
Reply from 10.0.1.1: bytes=32 time<1ms TTL=255
user1 # get system interface
== [ internal ]
namE. internal modE. static ip: 10.0.1.254 255.255.255.128 status: up
netbios-forwarD. disable typE. physical mtu-overridE. disable
== [ vlan1 ]
namE. vlan1 modE. static ip: 10.0.1.1 255.255.255.128 status: up netb
ios-forwarD. disable typE. vlan mtu-overridE. disable
user1 # diagnose debug flow trace start 100
user1 # diagnose debug ena
user1 # diagnose debug flow filter daddr 10.0.1.1 10.0.1.1
id=20085 trace_id=274 msg="vd-root received a packet(proto=6, 10.0.1.130:47927->10.0.1.1:443)
from internal."
id=20085 trace_id=274 msg="allocate a new session-00000b1b"
id=20085 trace_id=274 msg="find SNAT: IP-10.0.1.1, port-43798"
id=20085 trace_id=274 msg="iprope_in_check() check failed, drop"
Based on the output from these commands, which of the following explanations is a possible cause of the problem?

Correct Answer: B
Question 6
For Data Leak Prevention, which of the following describes the difference between the block and quarantine actions?

Correct Answer: C
Question 7
In order to load-share traffic using multiple static routes, the routes must be configured with ...

Correct Answer: C
Question 8
Which of the following statements is correct about configuring web filtering overrides?

Correct Answer: B
Question 9
You are the administrator in charge of a FortiGate unit which acts as a VPN gateway. You have chosen to use Interface Mode when configuring the VPN tunnel and you want users from either side to be able to initiate new sessions. There is only 1 subnet at either end and the FortiGate unit already has a default route.
Which of the following configuration steps are required to achieve these objectives? (Select all that apply.)

Correct Answer: B,C,D,E
Question 10
When the SSL proxy inspects the server certificate for Web Filtering only in SSL Handshake mode, which certificate field is being used to determine the site rating?

Correct Answer: E