CompTIA RFID+ Certification - RF0-001 Exam Practice Test

A. Water

B. Foam

C. Glass

D. Green lumber

A. Circularly polarized

B. Linear

C. Waveguide

D. Isotropic

A. one

B. 9

C. 7

D. 6

A. Upgrading the RFID system to Electronic Product Code (EPC) Class 1 Gen 2 specifications.

B. Replacing the existing components that are interfering.

C. Turning off the RFID system.

D. Shielding the zone with a reflective or absorptive material.

A. Enable dense reader mode.

B. Replace the interrogators with updated models.

C. Add an EPC decoder to the middleware.

D. Perform a firmware upgrade.

A. are more susceptible to electrostatic discharge (ESD) than in-line automatic applicators.

B. make it difficult to optimize label application for the container.

C. are more likely to break the bond between the antenna and the chip.

D. are lower in cost than application in manufacturing.

A. be crushed.

B. be easier to read.

C. last longer.

D. be read at a higher rate.

A. 2.45 GHz UHF

B. 125 - 150 kHz low frequency (LF)

C. 860 - 960 MHz ultra high frequency (UHF)

D. 13.56 MHz high frequency (HF)

A. a tag constructed for fewer bits is being read.

B. the battery pack in the interrogator needs to be changed.

C. power to the interrogator is shorting out.

D. software filters are set too low.

A. decibels per meter.

B. Effective Radiated Power (ERP).

C. Effective Isotropic Radiated Power (EIRP).

D. decibels.

A. The interrogators have issued the kill command to the tags.

B. The new tags are the wrong type for the system.

C. The new tags are all bad.

D. A tag virus has been introduced by the new tags.

A. 0 C (32 F)

B. -80 C (-112 F)

C. 20 C (68 F)

D. -40C (-40 F)